Automatic Suction Pool Vacuum for Above Ground and In Ground Pools by XtremepowerUS

Instructions: XtremepowerUS Automatic Suction Vacuum Pool Cleaner will not go into a shallow end that is less than 3 ft. D. The hoses may not connect too tight so that the pool cleaner can move freely and reach more spots. Minor air leaking from the connection is normal. The cleaner will not pick up leaves and large particles. Simply connect to a pool pump of 3/4 HP or higher, or 1600 GPH or higher, recommended to function properly with this automatic pool cleaner. Then connect to a filter for better usage, the filter is recommended to be washed every-week and kept clean. The yellow seal clips functions as weighted stabilizers, properly used to keep the balance when you clean the pool. Recommended each seal clip for every 3 ft. of depth of your pool. Lastly, adjust or twist eyeball divert to change the flow of water and to make sure the water flowing can be inside with right direction.

• Eco-friendly automatic pool cleaner vacuum designed for high efficiency and low maintenance
• Automatic operation by self-navigating around the water on set patterns for top to bottom pool cleaning
• Soft and thickened pleated seal (base plate) able to gently and thoroughly clean for all sizes and shapes of swimming pools
• Effectively removes different types of debris from pool including algae, bugs, small pool dirt and dust from your pool area
• No wheels to cause jamming, no gears that break too often, and no diaphragms that needs to be replaced
• Recommended for in-ground or above-ground swimming pools up to 16 ft. x 34 ft., 544 sq. ft. maximum
• Filtration system: this unit operates simply by attaching to your pool filtration system, functions like a moving drain to move water through the filtration system
• Requirement: requires at least a minimum of 3/4 HP or 1600GPH (and higher) pool pump to properly function
• No tools or electricity required
• Automatic suction does not go up on to the wall if the pool wall angle is 90° and not curved